Extron-electronics IN1608 Series Setup Guide Manuel d'utilisateur télécharger pdf

IMPORTANT:

Go to www.extron.com for the

complete user guide, installation

instructions, and specifications.

IN1608 Series • Setup Guide

The Extron IN1608 Scaling Presentation Switcher is an eight input, HDCP-compliant

video scaler that accepts a wide variety of audio and video formats. This guide allows

an experienced user to set up and congure IN1608, IN1608 SA, and IN1608 MA

scalers. It covers how to perform basic operations using the front panel controls and

selected Simple Instruction Set (SIS™) commands.

NOTE: For full installation, configuration, menus, connector wiring, and

operation details, see the IN1606 and IN1608 Series User Guide, at

www.extron.com.

Installation

Rear Panel Features

100-240V ~ 1.0 A MAX

CONFIGURABLE

HDMI

RS-232 IR

Tx Rx Tx RxG

HDMI

INPUTS

OUTPUTS

Tx Rx

RS-232

LAN

RESET

AUDIO INPUTSOUTPUTSOUTPUTS

+48V

VARIABLE

IN1608

MIC/LINE

SIG LINK

DTP IN

SIG LINK

DTP IN

SIG LINK

DTP OUT

50-60 Hz

RS-232 IR

REMOTE

OVER DTP OVER DTP

ab cdgh efikl

Figure 1. IN1608 Series Shared Rear Panel Connectors

Power and Input Connections Output Connections Control Connections

AC power connector

Congurable analog 15-pin HD (VGA) connectors (inputs 1 and 2)

HDMI input connectors (inputs 3 through 6)

DTP input and corresponding RS-232/IR Over DTP connectors

(inputs 7 and 8)

Analog audio input connectors (associated with inputs 1 through 6)

Mic/Line audio input connectors and adjacent phantom power LEDs

DTP output connector and

corresponding RS-232/IR Over

DTP connector (output C)

HDMI output connectors

(outputs A and B)

Analog audio output connectors

Amplied audio output connectors

(IN1608 SA and IN1608 MA only)

LAN connector

RS-232 connector

Mounting and Cabling

Step 1 — Mounting

a. Turn off or disconnect all equipment power sources.

b. Mount IN1608 scalers to a rack using the pre-installed rack ears or use an optional

mounting kit for under-the-desk mounting. The IN1608 comes in a 1U, full rack width

enclosure. The IN1608 SA and IN1608 MA come in 2U, full rack width enclosures.

Step 2 — Connecting Inputs

a. Connect analog video sources to the VGA connectors (see b above).

b. Connect digital HDMI or DVI (with an appropriate adapter) sources to the HDMI

connectors (see c above).

c. Connect a DTP transmitter to the DTP input connectors (see d above). For cable wiring

and recommendations, see Twisted Pair Recommendations for DTP Communication

on page 2.

Signal LED — Lights green when the unit is receiving an active video signal from a DTP

transmitter.

Link LED — Lights amber when a valid link is established to a DTP transmitter.

d. To pass serial, infrared data, or other control signals, as for serial control of a source,

connect the control device to the RS-232 and IR Over DTP captive screw connectors

(see RS-232 and IR Over DTP Wiring on page 2).

e. Connect analog audio input sources to the 5-pole captive screw connectors

(see e above). For audio wiring, see Audio Wiring on page 2.

f. Connect Mic/Line audio input sources to the 3-pole captive screw connectors

(see f above).

Tx Rx

RS-232

LAN

2x25W(8Ω)/2x50W(4Ω)

RESET

OUTPUTS

REMOTE

CLASS 2 WIRING

VARIABLE

AMPLIFIED OUTPUT

Tx Rx

RS-232

LAN

70V - 100W

RESET

OUTPUTS

REMOTE

CLASS 2 WIRING

VARIABLE

AMPLIFIED OUTPUT

IN1608 SA IN1608 MA

Rack Ears

Rack Mounting

#8 Screw

(4) Places

Each Side

MBU 149

Mounting Bracket

Mounting Screws

(2) Places

Each Side

Furniture Mounting

1 2 3 4

Résumé du contenu

Page 1 - IN1608 Series • Setup Guide

1IMPORTANT:Go to www.extron.com for the complete user guide, installation instructions, and specifications.IN1608 Series • Setup GuideThe Extron IN160

Page 2 - Audio Wiring

2IN1608 Series • Setup Guide (Continued)Step 3 — Connecting outputsa. Connect a DTP receiver to the DTP output connector (see g on page 1). For cabl

Page 3 - 1 2 3 4 5 6 7 8

3Front Panel OverviewVOLUMESCALING PRESENTATION SWITCHERIN1608INPUTS1HDCPSIGNALOUTPUTSENTERMENUExtron2 3 4 5 6 7 8 A B CINPUTS1 2 3 4 5 6 7 8CONFIGab

Page 4 - Basic SIS Command Table

468-1916-50 Rev. A06 13Extron USA Headquarters+1.800.633.9876 (Inside USA/Canada Only) Extron USA - West: +1.714.491.1500 FAX: +1.714.491.151

Commentaires sur ces manuels

Pas de commentaire

Extron-electronics IN1608 Series Setup Guide Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Accessoires pour la vidéo Extron-electronics IN1608 Series Setup Guide. Extron Electronics IN1608 Series Setup Guide User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Accessoires pour la vidéo Extron-electronics IN1608 Series Setup Guide