Extron electronics DVI 104 Tx/Rx Guide de l'utilisateur

Naviguer en ligne ou télécharger Guide de l'utilisateur pour Amplificateurs audio Extron electronics DVI 104 Tx/Rx. Extron electronics DVI 104 Tx/Rx User guide Manuel d'utilisatio

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 5
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 0
IMPORTANT:
Go to www.extron.com for the
complete user guide, installation
instructions, and specifications.
1
DVI 104 TX/RX • User Guide
The Extron DVI 104 Tx and DVI 104 Rx are fiber optic transmitter and receiver units that extend DVI signals up to 500 meters
(1,640 feet) using four multimode fiber optic cables. Optional four-fiber multimode cables are available in varying lengths.
The transmitter plugs directly into the source device and the receiver plugs directly into the display device.
The transmitter and receiver pair can handle DVI video signals with resolutions up to 1920 x 1200 or 1080p at 60 Hz.
FCC Class A Notice
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part15 of the FCC
rules. The ClassA limits provide reasonable protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause interference. This interference must be corrected at the expense of the user.
NOTE: This unit was tested with shielded I/O cables on the peripheral devices. Shielded cables must be used to ensure
compliance with FCC emissions limits.
For more information on safety guidelines, regulatory compliances, EMI/EMF compatibility, accessibility, and related topics, see
the “Extron Safety and Regulatory Compliance Guide” on the Extron website.
FDA/IEC 60825-1 Requirements
CLASS 1 LASER PRODUCT
Complies with FDA performance standards for laser products except for deviations pursuant to Laser Notice No. 5, dated June 24,
2007.
The product is intended to be used with the fiber optic cables fully installed.
This product meets the applicable requirements of IEC 60825-1, Edition 1 (2007).
Any service to this product must be carried out by Extron Electronics and its qualified service personnel.
Application Diagram
PC with DVI Output
DVI 104
Transmitter
DVI 104
Receiver
Hi-resolution
Flat Panel Display
with DVI-D Input
4 Multi Mode
Fiber
Up to 500 meters (1640 feet)
Vue de la page 0
1 2 3 4 5

Résumé du contenu

Page 1 - DVI 104 TX/RX • User Guide

IMPORTANT:Go to www.extron.com for the complete user guide, installation instructions, and specifications.1DVI 104 TX/RX • User GuideThe Extron DVI 10

Page 2

DVI 104 TX/RX • User Guide2FeaturesPower supply — Separate power supplies are provided for both the transmitter and receiver.Power LEDs — The LEDs are

Page 3

DVI 104 TX/RX • User Guide3Rear Panel FeaturesMale Connector13 6817 19 22 2493c A single-link DVI-D male connector is used to connect the transmitter

Page 4

DVI 104 TX/RX • User Guide43. Press and release the EDID Minder programming button by gently inserting a pointed device, such as a paper clip, into t

Page 5

68-1549-01 Rev. D 12 13Extron Headquarters+800.633.9876 Inside USA/Canada Only Extron USA - West Extron USA - East+1.714.491.1500 +1.919.850.1000+1.

Commentaires sur ces manuels

Pas de commentaire