Extron electronics Multi-Rate SDI Fiber Optic Transceiver FOX HD-SDI Manuel d'utilisateur télécharger pdf (Page 12)

FOX HD-SDI • Installation and Operation

Installation and Operation, cont’d

2-6

FOX HD-SDI • Installation and Operation

2-7

Through-desk mounting

The transceiver can be mounted through a desk or other

furniture using an optional Extron MBD 129 through-desk

mounting kit, part #70-077-02. Mount the transceiver through a

desk or table as follows (ﬁgure 2-4):

Figure 2-4 — Through-desk mounting

1. Loosely attach the mounting brackets to the transceiver

using the four machine screws and washers supplied with

the mounting kit.

2. Hold the transceiver against the inside of the surface

through which it will be mounted. Mark the four screw

holes on the inside of the surface to which you are

mounting the device.

3. Drill four pilot holes, each 3/32" in diameter by 1/4" deep,

where you made marks.

4. Using the provided four wood screws, secure the brackets

to the mounting surface.

5. Slide the transceiver up and down in the mounting

brackets until the face of the transmitter or receiver is at

the desired height. Tighten the screws that secure the

brackets in place.

If the screws are inaccessible to a screwdriver:

a. On the transceiver, mark the location of the brackets

relative to the screws.

b. Remove the transceiver from inside the furniture.

c. Tighten the screws.

d. Replace the unit inside the surface (step 4).

Projector mounting

The transceiver can be mounted on a projector bracket using

either of the following optional Extron projector mounting kits:

• PMK 300 projector mounting kit (part #70-374-01)

• PMK 350 low proﬁle projector mounting kit

(part #70-563-02 [black] or part #70-563-03 [white])

PMK 300 mounting

Mount the transceiver to a PMK 300 bracket as follows:

1. If necessary, remove the feet from the bottom of the

transceiver.

2. Mount the transceiver to one of the bracket’s three

mounting plates using two of the supplied 4-40 x 3/16"

screws in opposite (diagonal) corners to secure the device

to the bracket. It can be vertically mounted facing either

up or down (ﬁgure 2-5).

On the side mounting plates, the device is typically

mounted on the outside of the bracket.

On the front mounting plate, the device is typically

mounted on the inside of the bracket.

Extron

PMK 300

Multi-product Projector Mount Kit

U-Bolt

Front Mounting

Plate

Side Mounting

Plate

Extron

FOX 500 HDSDI

Transceiver

Power Supply

Bracket

Brace

Figure 2-5 — PMK 300 projector mounting a transceiver

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19 20

Commentaires sur ces manuels

Pas de commentaire

Extron electronics Multi-Rate SDI Fiber Optic Transceiver FOX HD-SDI Manuel d'utilisateur Page 12

Commentaires sur ces manuels

Produits connexes et manuels pour Stands d'équipement audiovisuel Extron electronics Multi-Rate SDI Fiber Optic Transceiver FOX HD-SDI