Extron electronics TP T 15HD 45 Guide de l'utilisateur télécharger pdf (Page 9)

Ä Transmitter output connector — A female RJ-45 connector on a 3 inch pigtail for the

VTT001 MAAP, or within the VTT001 model. Plug this connector to the UTP cable going

to the receiver.

CAUTION: Do not connect the transmitter to a computer data or

telecommunications network.

Å Receiver input connector — A female RJ-45 connector on a 3 inch pigtail for the

VTR001 MAAP and VTR001 AAP models, or within the VTR001 model. Plug this

connector to the UTP cable coming from the transmitter.

CAUTION: Do not connect the receiver to a computer data or telecommunications

network.

Ç Captive screw input power connector — Connect the included

Power Connection

–

12VDC

Power

12 VDC external power supply to the 2-pole female direct insertion

captive screw connector. The VTT001 MAAP, VTR001 AAP, and the

VTR001 MAAP have this captive screw connector.

VTT001 Power Wiring.eps

Power Supply

Output cord

SECTION A–A

CAUTIONS: • Always use a power supply supplied by or specified by Extron. Use

of an unauthorized power supply voids all regulatory compliance

certification and may cause damage to the supply and the end

product.

• Unless otherwise stated, the AC/DC adapters are not suitable for

use in air handling spaces or in wall cavities. The power supply is

to be located within the same vicinity as the Extron A/V processing

equipment in an ordinary location, Pollution Degree 2, secured to

the equipment rack within the dedicated closet, podium or desk.

• The installation must always be in accordance with the applicable

provisions of National Electrical Code ANSI/NFPA 70, article 75 and

the Canadian Electrical Code part 1, section 16. The power supply

shall not be permanently fixed to building structure or similar

structure.

To verify correct polarity before connection, check the power supply no load output with

a voltmeter.

WARNING: The two power supply leads must be kept separated while the power

supply is plugged into an electrical outlet. Remove power before

wiring.

VTT001 and VTR001 User Guide • Installation 4

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 26 27

Pas de commentaire

Extron electronics TP T 15HD 45 Guide de l'utilisateur Page 9