Extron-electronics FOX II T_R DP User Guide Manuel d'utilisateur télécharger pdf (Page 20)

FOX II DP Transmitter and Receiver • Installation and Operation

Audio output connector

See figure 9, below, to properly wire a captive screw output connector, either audio output

on the receiver or return audio output on the transmitter. The connector is included with

transmitter, but you must supply the audio cable. Use the supplied tie-wrap to strap the

audio cable to the extended tail of the connector.

Unbalanced Stereo Output Balanced Stereo Output

Do not tin the wires!

Tip

No Ground Here

Tip

Sleeves

Tip

Ring

Tip

Ring

Sleeves

Figure 9. Captive Screw Connector Wiring for Stereo Audio Output

ATTENTION: For unbalanced audio, connect the sleeves to the ground contact.

DO NOT connect the sleeves to the negative (-) contacts.

NOTE: The length of exposed wires is important (see the first two RS-232 and IR

connector NOTES on page 12 for more information).

Alarm connection

Pin 1 and pin 2 are

shorted together when

no light is detected.

Do not tin the wires!

RS-232

ALARM

1 2 Tx RxG

REMOTE

Figure 10. Alarm Connector

NOTE: The length of exposed wires is important (see the first two RS-232 and IR

connector NOTES on page 12 for more information).

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

Pas de commentaire

Extron-electronics FOX II T_R DP User Guide Manuel d'utilisateur Page 20