Extron electronics Four Input Video and RGB Scaler DVS 304 Instructions d'exploitation télécharger pdf (Page 15)

2-3

DVS 304 • Installation and Operation

Rack mounting the DVS 304

1. If feet were installed on the bottom of the DVS 304, remove them.

2. Place the DVS 304 on one half of the 1U (one unit high, one unit wide) rack

shelf (part #60-190-01). Align the front of the DVS 304 with the front of the

shelf, and align the threaded holes on the bottom of the DVS 304 with the

holes in the rack shelf.

3. Attach the DVS 304 to the rack shelf with the two provided 4-40 x 1/16"

machine screws. Insert the screws from the underside of the shelf, and

securely fasten them into diagonally-opposite corners (ﬁgure 2-1).

(2) 4-40 x 3/16" Screws

Use 2 mounting holes on

opposite corners.

False front panel

uses 2 front holes.

Figure 2-1 — Rack mounting a half rack device

4. Attach the false front panel (provided with the universal rack shelf) to the

unoccupied side of the rack (as shown above), or install a second half-rack-

width device in that side by repeating steps 1 – 3.

5. Attach the rack shelf to the rack using four 10-32 x 3/4" bolts (provided).

Insert the bolts through #10 beveled washers, then through the holes in the

rack ears and rack (ﬁgure 2-1).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 95 96

Pas de commentaire

Extron electronics Four Input Video and RGB Scaler DVS 304 Instructions d'exploitation Page 15