Extron electronics VN-Matrix 325 Guide de l'utilisateur Page 24

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 82
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 23
4. Select the eth0 (upper Ethernet connector; primary network) device line to highlight it. If
there is a network cable present and it is connected to a switch, the status should read
Active.
5. Click Deactivate. The status of the eth0 device should now read Inactive.
6. Double‑click on the eth0 device. The Ethernet Device window appears (see figure 12).
Figure 12. Ethernet Device Window
7. Change the Address and Subnet mask fields as required and then click OK.
NOTE: The Default gateway address field is only required if devices are on
different subnets.
8. Navigate back to the Network Configuration window (see figure 11). Select the
eth0 device and then click Activate.
VNM Recorder • Recorder Conguration and Hardware Setup 18
Vue de la page 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 81 82

Commentaires sur ces manuels

Pas de commentaire