Extron electronics CS 120P Guide de l'utilisateur télécharger pdf (Page 20)

20. Mount the CS 3T (see figure 21).

a. Insert the CS 3T through the bottom of the hole in the ceiling tile that was cut in

step 3.

b. Tighten the four locking arm screws (clockwise) until the speaker is securely

clamped to the ceiling.

Mounting the Speaker

with the CS 120P

Mounting the Speaker

without the CS 120P

Figure 21. Mounting the Speaker

ATTENTION:

• To avoid damaging the speaker, do not overtighten the four screws. Use

a manual screwdriver to tighten the screws. Do not use a cordless drill or

electric screwdriver.

• Pour éviter d’endommager l’enceinte, ne serrez pas trop les quatre vis. Utilisez

un tournevis manuel pour serrer les vis. N’utilisez pas de perceuse-visseuse ou

de tournevis électrique.

NOTE: If the CS 3T was installed with the CS 120P skip step 21.

CS 3T and CS 120P User Guide • Installation 15

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 36 37

Pas de commentaire

Extron electronics CS 120P Guide de l'utilisateur Page 20