Extron-electronics MLA-VC10 Manuel d'utilisateur télécharger pdf (Page 39)

MLA-VC10 • Conﬁguration and Operation

3-11

DIP switches

Using the table on the two following pages, select the voltage

that is closest to the control voltage of the amplifer or mixer (see

"Determining the Control Voltage" on pages 2-3 to 2-7). Note the

conﬁguration of the DIP switches that is needed to achieve that

voltage and set the DIP switches on the rear panel of the MLA-

VC10 in that conﬁguration.

The switch must be fully up or fully down. An

intermediate setting causes the MLA-VC10 to oscillate

erratically between the two possible values.

CONFIGURATION

0 to 10.0 VDC 0 to 4.98 VDC NOT HALFWAY

DOWN

CONFIGURATION

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 51 52

Pas de commentaire

Extron-electronics MLA-VC10 Manuel d'utilisateur Page 39