
CTP150CM Remote Control Panel • Installation and Operation
CTP150CM Remote Control Panel • Installation and Operation
Installation and Operation, cont’d
2. If not already accomplished, attach the 8-conductor cable
to the rear of the remote control panel.
3. Mount the CPM101 or other mini-AAP panel (with the
attached remote control panel) to the wall box or
mounting bracket using the two included mounting
screws (figure 2-5).
Figure 2-5 shows a wall box installation. Mounting the
mini-AAP panel to a mounting bracket is identical.
4. Power on all devices.
Rear Panel Setup
GND
PROJ PWR
VOL D N
VOL U P
IN4
IN3
IN2
IN1
CONTACT
CLOSURE
MADE IN USA
GND
PROJ PWR
VOL DN
VOL UP
IN4
IN3
IN2
IN1
CONTACT
CLOSURE
TPT150
Switching
Transmitter
Input 1
Input 2
Input 3
Input 4
Volume up
Volume down
Projector power
Ground
CTP150CM Control Panel
1
Figure 2-6 — Rear panel view
1
Contact closure connector — This connector is a 3.5 mm, 8-pole
captive screw connector for contact closure connections.
Connect a Category (Cat) 5 cable or any 8-conductor cable
between the remote control panel and the switching transmitter,
as shown in figure 2-6.
2-72-6
6. If you are using a mounting bracket, follow the directions,
if any, that came with the mounting bracket to attach the
clips that fasten the bracket to the wall or furniture (figure 2-4).
Push Mounting
Tabs Forward
Wall
Extron
IN9181 Wall
Mounting Bracket
Figure 2-4 — Attaching a mounting bracket to a wall
Wall Mounting
1. Sandwich the mini-AAP panel (such as a CPM101)
between the body of the remote control panel and the
printed front panel. Secure the front panel to the remote
control panel body with the included #4-40 screws
(figure 2-5).
Wall opening
flush with
edge of box
Front Panel
Extron
CTP150CM
Control Module
Extron
CPM101
A/V Connector Panel
PC 1
PC 2
VIDEO 1
VIDEO 2
VOL
UME
UP
DOWN
PROJECTOR
POWER
Figure 2-5 — Attaching the mini-AAP panel to a wall box
Commentaires sur ces manuels