Extron-electronics DTP T UWP 232_332 D User Guide Manuel d'utilisateur télécharger pdf (Page 20)

DTP T HWP/UWP 232/332 D Transmitters • Installation and Operation 14

RS-232 and IR Connector Wiring

Remote RS-232 and Contact Closure Connector

Wire the rear Remote RS-232 and contact closure connector as shown in figure 11.

Ground

Receive pin on connected unit

Transmit pin on connected unit

Connected RS-232 and

Contact Closure Device Pins

Tx/Rx

Pins

Pin 1 f

or contact closure control

Pin 2 f

or contact closure control

RxTx

RS-232 Contact

REMOTE

Figure 11. RS-232 and Contact Closure Connector Wiring

IR Control Connector

Wire the front panel IR control connector as shown in figure 12.

Groun

Signal

Figure 12. IR Out Connector Wiring

Over DTP RS-232 Connector

Wire the rear Over DTP RS-232 connector as shown in figure 13.

Tx Rx G

OVER DTP

Ground

Receive pin on connected unit

ansmit pin on connected unit

Figure 13. Over DTP Connector Wiring

NOTE: Do not tin the wires before installing them in the direct insertion connector.

Tinned wires are not as secure in the connectors and could be pulled out.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 30 31

Pas de commentaire

Extron-electronics DTP T UWP 232_332 D User Guide Manuel d'utilisateur Page 20