Extron-electronics MLM-WB+ User Guide Manuel d'utilisateur télécharger pdf (Page 21)

2-15MLM-WB • Installation

9. Install and adjust the clamp plate assembly.

9a. Place the clamp plate assembly into the MLM-WB enclosure and route

the VCR’s power and A/V cables around it, away from the bottom of the

VCR, where the clamp plate will go.

9b. Align the holes in the top plate with the screw posts on the rear wall, and

install and securely tighten the nuts. Align the holes in the base of the

front plate with the slits in the bottom of the enclosure. Insert and

loosely fasten the screws from the outside of the enclosure.

Tighten

(3) #632 Nuts

with Washers.

#440, 1/4" Pan

Head Screws

(3 places)

Top Clamp Plate

Front Clamp Plate

9c. Press the front clamp plate toward the wall until it fits snugly against the

VCR’s bottom panel. Firmly tighten the screws to fasten the clamp plates

in place.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 33 34

Pas de commentaire

Extron-electronics MLM-WB+ User Guide Manuel d'utilisateur Page 21