Extron-electronics MTP U T A D User Guide Manuel d'utilisateur télécharger pdf (Page 8)

MTP U T A D • Introduction 2

Twisted Pair Cable

Twisted pair (TP) cable is much smaller, lighter, more flexible, and less expensive than coaxial

cable. These TP products make cable runs simpler and less cumbersome. Termination of the

cable with RJ-45 connectors is simple, quick, and economical.

Transmission Distance

NOTE: This transmitter provides pre-peaking, which boosts the signal before it is

transmitted.

The maximum distance is determined by the frequency and resolution of the signal that is

input to the transmitter. The table on the next page specifies the recommended maximum

transmission distances and transmitter Pre-Peak switch positions (refer to the applicable

transmitter guide) using Extron Enhanced Skew-Free A/V UTP cable or UTP CAT 5, 5e, or

6 cable, terminated with RJ-45 connectors.

NOTES: • It is possible to exceed the recommended distance; however, image quality

may be reduced.

• The MTP units are designed for and perform best with Extron Enhanced

Skew-Free A/V

cable terminated in accordance with the TIA/EIA T 568 A

wiring

standard. CAT 5, 5e, and 6 cables are acceptable, but less preferable. We also

recommend the use of preterminated and tested cables. Cables terminated on

site should be tested before use to ensure that they comply with Category 5

specifications.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

Pas de commentaire

Extron-electronics MTP U T A D User Guide Manuel d'utilisateur Page 8