Extron-electronics P-2 DA2xi Setup Guide Manuel d'utilisateur télécharger pdf

Setup Guide — P/2 DA2xi

This guide provides basic instructions for an experienced

installer to set up and operate the Extron P/2 DA2xi.

Installation

The P/2 DA2xi is a high performance one input, two

output distribution ampliﬁer that accepts video input from

a VGA-QXGA compatible PC and distributes that signal to separately buffered outputs. See

the following application diagram.

Extron

P/2 DA2xi

VGA Distribution Amplier

Projector

INPUT

Extron

VGA Cable

Up to 250 feet (76 m)

Installation and service must be performed by authorized personnel only.

Step 1 — Power down

Power off the display device, the PC, and the PC’s local monitor.

Step 2 — Connect input

Connect the PC’s VGA output to the 15-pin HD Input on the front panel of the P/2 DA2xi

distribution ampliﬁer.

Step 3 — Connect outputs

• Connect the PC’s monitor to the Local Monitor 15-pin HD output connector of the

P/2 DA2xi.

• Connect the display device to the Output 15-pin HD connector of the P/2 DA2xi.

Step 4 — Set DIP switches

Set DIP switches 1 and 2 for input and output impedance and set DIP switch 3 for

gain/peaking:

Switch1(syncinputimpedance) – Default setting is down

(510 ohms). If the image from a laptop computer becomes unstable, slide the switch

up (10k ohms).

Switch2(syncoutputimpedance) – Default setting is up (50 ohms). If the front LED

is green and all the input and output cables are properly connected, but there is no

image at the projector, slide the switch down (75 ohms).

Switch3(videogain/peaking) – Slide the switch down (off) if the output cable

length is under 100 feet (30 m). Slide the switch up (on) if the output cable length is

over 100 feet (30 m).

The gain/peaking switch does not affect the local monitor output.

(Continued on reverse side)

OFF

1 2 3

1 2

Setup Guide — P/2 DA2xi 1

Résumé du contenu

Page 1 - Setup Guide — P/2 DA2xi

Setup Guide — P/2 DA2xiThis guide provides basic instructions for an experienced installer to set up and operate the Extron P/2 DA2xi.InstallationThe

Page 2

Setup Guide — P/2 DA2xiExtron USA - West Headquarters+800.63 3.9876Inside USA / Canada Only+1.714.491.1500+1.714.491.1517 FA XExtron USA - East+800.6

Commentaires sur ces manuels

Pas de commentaire

Extron-electronics P-2 DA2xi Setup Guide Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Extron-electronics P-2 DA2xi Setup Guide. Extron Electronics P-2 DA2xi Setup Guide User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Extron-electronics P-2 DA2xi Setup Guide