Extron-electronics RGB 400xi Series User Guide Manuel d'utilisateur télécharger pdf (Page 14)

RGB 460xi Series • Installation and Operation2-6

Blank plates (two single space and one double space) are

included with the interfaces to cover unused spaces. Adapter

plates must be ordered separately (see “Adapter Plates” in

appendix A). They must also be attached to the faceplate and

cabled before the interface is installed in the wall or furniture.

The screws needed for installing the adapter plates are supplied

(MAAPs), or built into the plates (AAPs), so no additional

screws are needed.

1. Remove the blank plates from the interface by unscrewing

the hex screws (MAAPs) or nuts (AAPs) that fasten the

plates to the faceplate.

2. Attach the adapter plates to the faceplate with the

provided hex screws (MAAPs) or captive washers and #4-

40 nuts (AAPs).

3. Attach the output cables to the rear connectors of the

adapter plates. Soldering will be required for some

connectors. Attach foil and braided shields to ground

connections.

Rear Panel Features and Cabling

Rear panel of the RGB 464

xixi

interface

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Pas de commentaire

Extron-electronics RGB 400xi Series User Guide Manuel d'utilisateur Page 14