Extron-electronics SCP 104 Series User Guide Manuel d'utilisateur télécharger pdf (Page 13)

Fig_Replacing button label

TEXT

Separate the two-

piece button here at

the corner.

Pry the two

pieces apart.

Diffuser

Plunger

Base

Button Label

Clear Cap

Notch

Figure 3. Replacing a Button Label

4. Lift out the transparent square label that you want to

replace, being careful not to damage the circuits beneath it.

You may need to use the small screwdriver to gently pry the

label out.

5. Detach one of the preprinted labels or one of the blank

labels from the label sheets included with the SCP. Remove

the label from the backing and, if applicable, peel the

protective ﬁlm from the front of the label.

NOTE: If desired, you can create customized labels using

a label maker, such as the Brother

P-touch

, and

clear label material. Cut the labels so that they

are square and measure ½ inch on each edge.

6. Insert the new label into the clear button cap, aligning the

white diffuser with the cap, and ﬁrmly snap the cap into

place.

7. Gently, but ﬁrmly, press the reassembled button into place

on the SCP front panel.

8. Repeat steps 1 through 7 as needed to relabel other

buttons.

SCP 104 and SCP 226 • Installation and Operation

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

Pas de commentaire

Extron-electronics SCP 104 Series User Guide Manuel d'utilisateur Page 13