Extron-electronics SCP 250 User Guide Manuel d'utilisateur télécharger pdf (Page 13)

SCP 250 • Installation and Operation

2-5

DIP switches — Set these switches to indicate

what model of system switcher the SCP is

attached to.

1, 2, 3, 4

— Input number identication — See the table below

for the appropriate settings for each SCP address.

5, 6, 7 — Not used — Keep these set to the closed/up position.

— Switcher model identication

Closed/up — System 7SC

Open/down — System 5cr Plus

1 2 3 4 5 6 7 8

* 1

1 0 0 0 0 0 0 * 2

* 3

1 1 0 0 0 0 0 * 4

* 5

1 0 1 0 0 0 0 * 6

* 7

1 1 1 0 0 0 0 * 8

* 9

1 0 0 1 0 0 0 * 10

* 11

1 1 0 1 0 0 0 * 12

* 13

1 0 1 1 0 0 0 * 14

* 15

1 1 1 1 0 0 0 * 16

DIP Switch Number

SCP

Address

*For switch 8

0 = System 7SC

1 = System 5cr Plus

For all switches

0 = closed (up)

1 = open (down)

On each SCP in a system, switch 8

must be set to the correct position

for the switcher model.

SCP DIP switch assignments

Cabling

For each SCP to be connected to a system switcher, set the rear

panel DIP switches, then follow these steps:

1. If it wasn’t done when the wall box was installed, cut

a length of Extron CTL Series Comm-Link cable to go

between the switcher and the SCP.

2. Using the following diagrams as a guide, attach a 3.5 mm,

5-pole captive screw connector to each end of the cable.

3 412

7 856

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Extron-electronics SCP 250 User Guide Manuel d'utilisateur Page 13

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Extron-electronics SCP 250 User Guide