Extron-electronics SGS 408 User Guide Manuel d'utilisateur télécharger pdf (Page 45)

4-3SGS 408 Switcher • Serial Communication

SGS error responses

When the switcher receives an SIS command and determines that it is valid, it

performs the command and sends a response to the host device. If the switcher is

unable to perform the command because the command is invalid or contains

invalid parameters, the switcher returns an error response to the host. The error

response codes are:

E01 — Invalid input number (too large)

E10 — Invalid command

E11 — Invalid preset

E12 — Invalid output number (too large)

E13 — Invalid value (out of range)

E23 — Checksum error

Using the command/response table

The command/response table begins on the next page. Lower case letters are

acceptable in the command field only where indicated. Symbols are used

throughout the table to represent variables in the command/response fields.

Symbol definitions are shown at the beginning of the response table, as is an

ASCII-to-hexadecimal conversion table. Command and response examples are

shown throughout the table.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 63 64

Pas de commentaire

Extron-electronics SGS 408 User Guide Manuel d'utilisateur Page 45