Extron electronics MTPX Plus Series Guide d'installation télécharger pdf (Page 11)

Refer also to the MTPX Plus User’s Manual at www.extron.com.

Ethernet port — If desired, connect a network WAN

or LAN hub, a control system, or a computer to the

Ethernet RJ-45 port.

Network connection• — Wire as a patch (straight) cable.

Computer or control system connection• — Wire the

interface cable as a crossover cable.

The factory default IP address is 192.168.254.254.

Power

Power connector — Plug the switcher into a grounded AC

source.

Front Panel

AUDIO

VIDEO

I/O

CONTROL

ENTERPRESET

VIEW

ESC

MTPX PLUS SERIES SWITCHER

CONFIG

Figure 2-7 — Front panel conﬁguration port

Conﬁguration port — If desired, connect a control system

or computer to the front panel Conguration (RS-232) port.

Use an optional 9-pin D to 2.5 mm mini jack TRS RS-232

cable, part #70-335-01.

Chapter Three

Front Panel Operation

Creating a Tie

Saving or Recalling a Preset

Setting the Front Panel Locks (Executive Modes)

Deﬁning the Audio/RS-232 Wire Pair (and Conﬁguring the Remote Port)

Viewing and Adjusting the Audio Level

Viewing Ties (and Muting Outputs)

Video Adjustments

MTPX Plus • Installation

Installation, cont’d

2-6

MTPX Plus Matrix Switcher

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Pas de commentaire

Extron electronics MTPX Plus Series Guide d'installation Page 11