Extron electronics SW 6 CV MX Instructions d'exploitation télécharger pdf (Page 22)

Installation, cont’d

System 7SC • Installation2-10

The pin assignments are as follows:

Signal

Display power/current sensor detection

Carrier & signal

Gnd

+12V

Wire the connector using one of the following wiring options.

Carrier & signal

Gnd*

System 7

IR Comm

port

For the IR Emitter only

Emitter

White striped wire only

IR COMM

ABCDE

Carrier & signal

Gnd

+12V

System 7

IR Comm

port

For the IR Broadcaster with emitter port

IR COMM

ABCDE

Signal

System 7

IR Comm

port

For a wired projector remote port

IR COMM

ABCDE

To projector's

wired remote

port

Tip

(signal)

Sleeve

(Gnd)

To IR Broadcaster

with emitter port

(#60-272-02)

IR Communications port wiring options

For some projectors the emitter must be used together with the IR Broadcaster.

Refer to the IR Broadcaster User’s Guide (part #68-392-02) or contact an

Extron support representative for details.

Projector control port — Connect a cable between the projector and this

3.5 mm, 10-pole captive screw connector for RS-232 or RS-422 one- or two-

way projector/display device control. Commands from a downloaded

projector control program or user-defined command strings entered via the

Windows-based control program can be sent to the display device from this

port.

Use the illustration below as a guide to wiring the connector. Wiring will vary

depending on the projector model. In most cases only the transmit (Tx) and

ground connections will be needed.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 73 74

Commentaires sur ces manuels

Pas de commentaire

Extron electronics SW 6 CV MX Instructions d'exploitation Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs de réseau Extron electronics SW 6 CV MX