Extron electronics System 10 Plus Instructions d'exploitation télécharger pdf (Page 22)

Installation, cont’d

System 7SC • Installation2-10

The pin assignments are as follows:

Signal

Display power/current sensor detection

Carrier & signal

Gnd

+12 V

Wire the connector using one of the following wiring options.

IR Emitter

White Striped Wire Only

100'

(30.5 m)

(Demodulated IR)

Carrier & Signal

Gnd*

System 7

IR Comm

Port

For the IR Emitter only

IR COMM

ABCDE

Carrier & signal

Gnd

+12 V

System 7

IR Comm

Port

For the IR Broadcaster with emitter port

IR COMM

ABCDE

Signal

System 7

IR Comm

Port

For a wired projector remote port

IR COMM

ABCDE

To the projector's

wired remote port

(Connector type

and pin

configurations may

vary depending on

the projector

model.)

To IR Broadcaster

with emitter port

(#60-272-02)

IR Communications port wiring options

For some projectors the emitter must be used together with the IR Broadcaster.

Refer to the IR Broadcaster User’s Guide (part #68-392-02) or contact an

Extron support representative for details.

Projector control port — Connect a cable between the projector and this

3.5 mm, 10-pole captive screw connector for RS-232 or RS-422 one- or two-

way projector/display device control. Commands from a downloaded

projector control program or user-defined command strings entered via the

Windows-based control program can be sent to the display device from this

port.

Use the following illustration as a guide to wiring the connector. Wiring will

vary depending on the projector model. In most cases only the transmit (Tx)

and ground connections will be needed.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 73 74

Commentaires sur ces manuels

Pas de commentaire

Extron electronics System 10 Plus Instructions d'exploitation Page 22

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs de réseau Extron electronics System 10 Plus