Extron-electronics Dante Controller Manuel d'utilisateur télécharger pdf (Page 33)

Dante Controller User Guide

-33-

the “Control” key when following the instructions below, and substitute standard Mac key

combinations where applicable – see the Dante Controller menu for details.

The label of the device being viewed is displayed in the middle of the toolbar. In the screenshot above,

Weyland-D8 is the device being displayed in the drop-down list box.

The device viewed can be changed by selecting another device from the drop-down list.

Multiple Device View windows may be opened from the Network View, so that several devices can be

examined simultaneously.

The Device View has up to five sub-views allowing the user to see different information relating to a

specific Dante device:

n Receive: display and configure device’s receive (Rx) channels

n Transmit: display and configure device’s transmit (Tx) channels including multicast

n Status: device software, clock and network status information

n Config: rename device and set other attributes as relevant to device type

n Baseboard: only available when the Dante device is mounted on a Dante PDK audio baseboard

(NOTE: the device must be in SPI Master mode)

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 54 55

Pas de commentaire

Extron-electronics Dante Controller Manuel d'utilisateur Page 33