Extron-electronics AVTrac Demonstration Kit Manuel d'utilisateur télécharger pdf

PRELIMINARY

Setup Guide for AVTrac

™

Demonstration Kit

68-1530-01

Rev. B 02 09

Connectivity Box (1)

Carpet Finish

Cover Track (1)

Rubber finish

Cover Track (1)

AC Conduit (1)

Side Ramps (2)

End Ramps (2)

Base Tr ack (1)

Pre-cut

Carpet Pieces (2)

The AVTrac Demonstration Kit shows how the AVTrac system meets customers' application needs. The kit components

can be unpacked from the carrying box as shown in the ﬁgures below. To repack the kit, reverse the steps.

The illustrations below show the US version of the AVTrac Demonstration kit. The International and Universal

models are similar in size and packaging, but contain a single AC outlet, which may be connected to double insulated

power cable, or ﬂex conduit without wires.

If the box is to be reused, remember to save

the packing foam.

Remove top foam and foam

covering side ramps.

Remove side and end ramps.

4. Remove track pieces and

connectivity box with AC

conduit.

This kit is for demonstration

purposes only. The AC power module is not

wired to distribute power and must not be

connected to an electrical power source.

1. Remove carpet pieces.

1 2

PRELIMINARYSetup Guide for AVTrac™ Demonstration Kit68-1530-01Rev. B 02 09Connectivity Box (1)Carpet FinishCover Track (1)Rubber finishCover Track (1

Page 2

Pas de commentaire

Extron-electronics AVTrac Demonstration Kit Manuel d'utilisateur