Extron-electronics AVTrac Raceway Transition Manuel d'utilisateur télécharger pdf

Extron® AVTrac

Raceway Transition • User Guide

The AVTrac Raceway Transition provides a clean and efﬁcient transition from the

ﬂoor‑mounted AVTrac to a wall‑mounted raceway (not provided).

For complete information about installing the AVTrac system, see the AVTrac User Guide,

which is available on the Extron website (www.extron.com).

The two available versions are:

z Compatible with the Wiremold 4000 series (shown in the illustrations)

z Compatible with most Euro Channel trunk systems. The Euro Channel kit does not have

the rabbit ears.

NOTE: The Euro Channel version ﬁts wall‑mounted raceways with dimensions

90 ‑ 120 mm (3.5 ‑ 4.7 inches) wide x 50 ‑ 65 mm (2.0 ‑ 2.6 inches) deep.

Install either model as follows:

1. Install the AVTrac so that it runs up to and meets

the foot of the wall. Do not ﬁx the cover track to

the base track or cover the ramps with carpet at

this time.

2. Remove the two screws holding the front plate in

position and lift it away from the transition unit

(see the ﬁgure at right).

3. Place the transition unit on top of the base track

of the AVTrac and against the wall. Mark the

positions of at least two mounting holes in the

base.

NOTE: If only two screws are used to secure the raceway transition, they must be in

diagonally opposite corners of the base.

4. Drill holes, 5/32 inches (0.4

cm) diameter and 1 1/2 inches

(3.8 cm) deep, through the

AVTrac and into the concrete

ﬂoor.

5. Using the masonry screws

provided, secure the raceway

transition unit to the ﬂoor.

6. Install the wall‑mounted

raceway following the

instructions provided by the

manufacturer.

The Wiremold version of the

kit has rabbit ears on the sides,

which ﬁt inside the raceway.

There are no rabbit ears on

the Euro Channel version and

the wall‑mounted raceway is

secured to the wall so that it

sits on top of the transition

unit.

Front Plate

Screws (2)

AVTrac

Raceway

Transition

Mounting

Holes

Wall-mounted

Raceway

(2) Masonry

Screws

Rabbit Ear

(Wiremold kit only)

AVTrac Raceway (base)

1 2

Extron® AVTrac 1

Résumé du contenu

Page 1 - Extron® AVTrac

Extron® AVTrac® Raceway Transition • User GuideThe AVTrac Raceway Transition provides a clean and efﬁcient transition from the ﬂoor‑mounted AVTrac to

Page 2

Extron® AVTrac® Raceway Transition • User Guide (cont’d)68‑1604‑01 Rev. B 12 10Extron USA - West Headquarters+800.633.9876Inside USA and Canada Only+

Commentaires sur ces manuels

Pas de commentaire

Extron-electronics AVTrac Raceway Transition Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Matériel Extron-electronics AVTrac Raceway Transition. Extron Electronics AVTrac Raceway Transition User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Extron-electronics AVTrac Raceway Transition