Extron electronics 3G-AE 100 Guide de l'utilisateur télécharger pdf (Page 9)

3G-AE 100 • Panels and Cabling 4

c Loop Through connector — If necessary, plug in an output device to the

Loop Through connector. The SDI input signal is equalized, re-clocked, and routed

to the Loop Through connector. This connector may also be used for cascading to

another 3G-AE 100.

NOTE: It is not required to connect a device to the Loop Through connector in

order to extract audio from the input device.

d Analog Outputs — Connect up to four audio output devices to the Analog Outputs,

using a cable with a balanced or unbalanced 3.5 mm, 5-pole captive screw connector.

Wire as shown below.

Do not tin the wires!

Balanced Audio Output

Tip

Ring

Tip

Ring

Sleeves

Unbalanced Audio Output

Tip

No Ground Here

Tip

Sleeves

Figure 4. Analog Output Connector Wiring

ATTENTION: Connect the sleeve to the ground (Gnd) terminal. Connecting the

sleeve to a negative (-) terminal will damage the audio output circuits.

e Group Select DIP switch — see the Operation section on the next page for

instructions on using the Group Select DIP switch.

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Extron electronics 3G-AE 100 Guide de l'utilisateur Page 9