Extron-electronics Cable Retraction System Setup Guide Manuel d'utilisateur télécharger pdf (Page 5)

Product Category

Cable Retraction System • Getting Started

Remove two enclosure

screws (front and back) from

this position for horizontal

or angular (XL) mounting.

Enclosure screws

(front and back) removed.

Remove two enclosure screws

(front and back) from this position

for horizontal or angular mounting.

Install two enclosure screws

(front and back) in angular

mounting location.

Cable Stop Assembly

Enclosure

Move cable stop assembly

upward until the angular

mounting hole is visible.

To mount the retractor horizontally:

To mount XL model retractors in an angled position for increased under-table clearance:

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Extron-electronics Cable Retraction System Setup Guide Manuel d'utilisateur Page 5