Extron-electronics Cable Retraction System Setup Guide Manuel d'utilisateur télécharger pdf (Page 6)

Cable Retraction System • Setup Guide (Continued)

Cable Retraction System • Installation

Installation

The enclosure must be installed and properly congured before beginning the retractor system installation.

1. With the cable release buttons against the enclosure wall, install the retraction system by pushing the system up and into the

enclosure.

2. Press the mounting bolt through the second hole from the edge of the Cable Cubby enclosure, through the retraction system,

then out the other side of the enclosure.

3. Thread the nut on the bolt and tighten.

ATTENTION: Do not overtighten the enclosure mounting bolt. It only needs to be snug.

Overtightening could deform the retractor housing and cause misalignment of the pulley wheels

resulting in malfunction.

4. Connect retraction system cables and other AAPcables (if installed).

Extron

Cable Retraction System

Cable Release

Buttons

Second Hole

from Edge

Second Hole

from Edge

5. If horizontally mounting the retraction system, proceed to “Horizontal Bracket Mounting” on page7.

6. For vertical and angular mounting, see “Locking Screw (Optional)” on page8 for nal installation details.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Extron-electronics Cable Retraction System Setup Guide Manuel d'utilisateur Page 6