Extron-electronics Cable Retraction System User Guide Manuel d'utilisateur télécharger pdf (Page 31)

Cable Retraction System • Maintenance and Adjustments 25

Removing and Replacing the System

To Remove the System:

DANGER: Ensure that AC power is disconnected before servicing the system.

1. Remove both ends of all retractor cables from connected devices.

NOTE: Drop-in installations require removal of the enclosure and retraction

system at the same time.

2. If necessary, loosen the locking screw on all retractors. If the system is mounted

vertically, proceed to step 6.

Loosen locking

screw (1 ea).

Figure 25. Loosen Locking Screws

3. Hold or otherwise support the cable retraction system near the horizontal bracket.

4. Remove the nut and slide the bolt from the horizontal mounting bracket.

CAUTION: All cable retractors attached to the horizontal mounting bracket will

drop when the bolt is removed.

Support the

retractor system.

Remove bolt.

Figure 26. Remove Horizontal Mounting Bolt

1 2 ... 26 27 28 29 30 31 32 33 34 35 36

Pas de commentaire

Extron-electronics Cable Retraction System User Guide Manuel d'utilisateur Page 31