Extron-electronics RJ-11 Installation Manuel d'utilisateur télécharger pdf (Page 9)

RJ-45 to RJ-11 Conversion Kit • HSA 400, 402 Installation

HSA 400, 402, Installation, cont’d

RJ-45 to RJ-11 Conversion Kit

Chapter Two

HSA 800, 802, 822 Installation

Introduction

Removing the HSA from the Table

Replacing the Connectors

Reassembling the HSA

Routing the AAP Cables

1-10

Routing the AAP Cables

1. Open the top panel to extend the AAP cables to their

maximum pull.

2. Experiment with AAP cable positioning to ensure that the

cables do not rub against the edges of the AAP cable hole

and to ensure that the cable pull does not restrict the

movement of the top panel. Figure 1-9 shows the cables

routed to the side, which proved effective in tests at

Extron.

3. Use tie wraps to secure the AAP cables to the tie-down

holes in the clamshell and enclosure.

Secure the AAP cables at the circled locations.

Rear View into HSA and Clamshell

Figure 1-9 — HSA 402 AAP cable routing

1 2 3 4 5 6 7 8 9 10 11 12 13

Pas de commentaire

Extron-electronics RJ-11 Installation Manuel d'utilisateur Page 9