Extron-electronics TLP 710CV User Guide Manuel d'utilisateur télécharger pdf (Page 24)

Initial

Conﬁguration

and Calibration

This section describes:

z How to Access the Internal On-screen Menus

z The Main, Volume, Time, Network, and Video screens

z The Touch Calibration Screen

How to Access the Internal On-screen Menus

When the TouchLink touchpanel rst has power applied, the unit boots up and displays the

opening screen. To access the on-screen menus, press the Menu button (see page 13).

The menus open at the Main screen. There are ﬁve different screens (Main, Volume, Time,

Network, and Video) that can be selected by pressing the appropriate button at the left side

of the screen.

There is also an

Exit button at the bottom left corner of the screen. Pressing this button

applies and saves any changes and leaves the menu screens.

Main Screen

Main

Volume

Time

Network

Video

Exit

OnDown Up

Sleep timer: 005 Min

Down Up

Backlight: 073%

Auto Backlight

PoE

Active

Figure 11. Main Screen

Values can be changed by pressing the buttons to highlight them. Press the Down or Up buttons

to adjust the values or press the Auto Backlight button to toggle between Off and On. The

current setting is shown above the buttons.

The sleep timer determines how long the touchpanel will be inactive before it enters Sleep

mode, when the screen goes dark to save power. The time can be changed from 0 to 833

minutes. The time that is currently selected is shown above the buttons.

TLP 710CV • Initial Conguration and Calibration 18

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 49 50

Pas de commentaire

Extron-electronics TLP 710CV User Guide Manuel d'utilisateur Page 24