Extron-electronics TP T 15HD 45, TP T A 45 User Guide Manuel d'utilisateur télécharger pdf (Page 13)

TP T 15HD 45 and TP T A 45 • Installation

2-3

Captive screw digital audio input connector — Connect the

digital audio input cables from the TP T A 45 (if installed) to the

2-pole female direct insertion captive screw connector.

Digital Audio Input Captive Screw

Direct Insertion Connector

AUDIO

Remove power before wiring.

The wire gauge should be 14 - 22 AWG and the

maximum distance betwee the modules should not exceed

25 feet.

Video and audio output 8-pin spring force connector —

Attach a UTP cable from a TP receiver to the 8-pin spring force

connector. Wire this connector according to the following pin

assignment table.

Twisted Pair Pin Assignments

Pin Signal

red / vertical sync +

red / vertical sync - green orange

digital audio + white-orange white-green

green + blue blue

green - white-blue white-blue

digital audio - orange green

blue / horizontal sync + white-brown white-brown

blue / horizontal sync - brown brown

TIA/EIA T-568-A

Wire Color

white-green white-orange

TIA/EIA T-568-B

Wire Color

T-568-A is recommended when using an Extron

Skew-Free

™

cable.

Do not connect the transmitter to a computer data

or telecommunications network.

Using a small screwdriver and observing the correct wiring

colors in the previous table, insert the stripped wire ends (see

note below) of the twisted pairs into the spring force connector,

as shown in the following diagram.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Pas de commentaire

Extron-electronics TP T 15HD 45, TP T A 45 User Guide Manuel d'utilisateur Page 13