Extron-electronics DTP T USW 233 User Guide Manuel d'utilisateur

User GuideDTP T USW 233DTP SystemsThree Input Switcher with Integrated DTP Transmitter68-2490-01 Rev. B01 14

DTP T USW 233 • Installation and Operation 5g Remote Tally port — If desired, to remotely identify the currently selected 123TALLY+V input, plug a l

DTP T USW 233 • Installation and Operation 6Supported cablesThe DTP T USW 233 is compatible with CAT 5e, 6, 6a, and 7 shielded twisted pair (F/UTP, S

DTP T USW 233 • Installation and Operation 7Power supply wiringNOTES:• The power supply included with the switching transmitter can normally power b

DTP T USW 233 • Installation and Operation 8IR and RS-232 connector wiringFigure 6 shows how to wire the Remote RS-232 and Over DTP RS-232 and IR con

DTP T USW 233 • Installation and Operation 9OperationControls and IndicationsHDCPSIGNALAUTOSWITCHDTP T USW 233CONFIG1STATUS23123MODENORMALAUTO2731 4

DTP T USW 233 • Installation and Operation 10Status LEDsg Status LEDs —Signal LEDs (1 through 3) — Indicates that the switcher detects Horizontal sy

DTP T USW 233 • Installation and Operation 11Selecting the switch modeNOTE: In the auto-input switching mode that is available from the front panel,

DTP T USW 233 • Remote Control 12Remote ControlThis section includes:• Contact Closure Control• Simple Instruction Set ControlThe DTP T USW 233 swit

DTP T USW 233 • Remote Control 13Simple Instruction Set ControlThe DTP T USW 233 switching transmitter can be remotely controlled using SIS commands

DTP T USW 233 • Remote Control 14Using the Command and Response TableThe command and response table begins on the next page. Symbols are used through

Safety InstructionsSafety Instructions • EnglishWARNING: This symbol, , when used on the product, is intended to alert the user of the presence of u

DTP T USW 233 • Remote Control 15Command and Response Table for SIS CommandsCommand FunctionSIS Command (Host to Unit)Response (Unit to Host)Addition

DTP T USW 233 • Remote Control 16Command FunctionSIS Command (Host to Unit)Response (Unit to Host)Additional descriptionEDID MinderNOTE: See table 1,

DTP T USW 233 • Remote Control 17Command FunctionSIS Command (Host to Unit)Response (Unit to Host)Additional descriptionInput 1 (only) video formatSe

DTP T USW 233 • Reference Information 18Reference InformationThis section provides procedures for mounting the DTP T USW 233 switching transmitter and

DTP T USW 233 • Reference Information 19UL Rack-Mounting GuidelinesThe following Underwriters Laboratories (UL) requirements pertain to the installat

DTP T USW 233 • Reference Information 203. Locate and lift off jumpers JMP1 and JMP2 (see figure 12).JMP1JMP2Figure 12. Jumper Locations4. Reinsta

Extron Headquarters+1.800.633.9876 (Inside USA/Canada Only)Extron USA - West Extron USA - East +1.714.491.1500 +1.919.850.1000 +1.714.491.1517 FAX +

FCC Class A NoticeThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part15 of the FCC rule

DTP T USW 233 • Introduction ivConventions Used in this GuideNotificationsThe following notifications are used in this guide:CAUTION: A caution indi

vDTP T USW 233 • IntroductionContentsIntroduction... 1About this Guide ...

DTP T USW 233 • Introduction 1Introduction• About this Guide• About the DTP T USW 233 Switcher• FeaturesAbout this GuideThis guide describes the Ex

DTP T USW 233 • Introduction 2TP CableExtron recommends XTP DTP 24 shielded twisted pair (STP) cable for best performance. Category (CAT) 5e, CAT 6,

DTP T USW 233 • Installation and Operation 3Installation and OperationThis section describes the installation and the operation of the DTP T USW 233,

DTP T USW 233 • Installation and Operation 4c Audio input port — If desired, plug an analog audio input into the switching AUDIO transmitter via thi