Extron-electronics CTL208CM Manuel d'utilisateur télécharger pdf (Page 16)

CTL208CM Control Panel Module • Serial Communications

Serial Communications, cont’d

4-2 4-3

The control panel module must be programmed before it can be

operated. Programming can include setting several serial port

variables to match the device to be controlled and includes

entering the primary and secondary (if applicable) code for each

button.

You can program the control panel module either by using the

ICS100 windows control program or by sending individual

ASCII commands. Both programming methods require that a

serial port cable be connected between a computer and the

control panel module’s serial port.

ICS100 Windows Control Program

The ICS100 Control Program, a graphical control software for

Windows, provides a way to program the control panel module.

System requirements

• Operating system —

Windows 95 / 98 / ME / NT / 2000 / XP / XP Pro

If using Windows NT, Service Pack 6 must be installed.

• Hardware — Pentium 150 or faster CPU

• Memory — Minimum: 128 MB

Recommended: 256 MB

• Screen resolution — Minimum: 800 x 600

Recommended: 1024 x 768

• Disk space — 5 MB

Installing the software

The control program is contained on a CD-ROM, and must be

installed on the hard drive.

1. Click Start > Run.

2. Click the Browse button. An open file window appears.

3. Navigate to the drive or folder that contains the software.

4. Double click the setup icon.

5. Click Ok in the Run window.

6. Click Ok in the InlineControl Setup window.

7. Click the icon button in the next InlineControl Setup to

install the software in the default (Extron) directory in the

Program group.

If you want to specify a different directory, click on the

Change Directory button.

8. The next InlineControl Setup window that appears

indicates when setup is complete. Click Ok.

Starting the program

Start the control program and establish communications with

the CTL208 as follows:

1. Click Start > Programs > Extron > ICS100. The control

program window (figure 4-1) appears.

The CTL208 will not respond until it has been contacted

with the valid address; after a moment, the program

reports a failure to connect (figure 4-1).

Figure 4-1 — ICS100 program window and warning

2. Click OK.

The control panel module’s serial port is factory-

configured to 9600 baud, no parity, no flow control, half-

duplex mode. If desired, serial port settings can be

changed from within the ICS100 program.

3. If you need to change serial port settings, click

Communications > Comm Port > Comm 1 (or the correct Comm

port). The Serial Port Setup window appears (figure 4-2).

Figure 4-2 — Serial Port Setup window

Serial Communications

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 24 25

Commentaires sur ces manuels

Pas de commentaire

Extron-electronics CTL208CM Manuel d'utilisateur Page 16

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Extron-electronics CTL208CM