Extron electronics IPL T S2 Instructions d'exploitation télécharger pdf (Page 14)

IPL T S Series • Installation and Operation

2-2

Installation and Operation

Installation Overview

To install and set up an IPL T S interface, follow these steps:

1. Turn all of the equipment off. Make sure that the video sources (DSS, cable

boxes, or other devices), the IPL T S unit, the output devices (monitors,

VCRs, projectors, and so on) and the serial controller are all turned off and

disconnected from the power source.

2. Mount the IPL T S interface. See “Mounting the IPL T S Interface”, below.

3. Attach the cables. See “Connecting the Hardware” in chapter 3.

4. Connect power cords and turn on the devices in the following order: output

devices (projectors, monitors, speakers), IPL T S interface, serial controller or

computer (PC), then input devices (DSS, cable boxes, and so on).

5. Conﬁgure the IPL T S interface through DataViewer or Telnet, then access the

unit using an Internet browser.

Mounting the IPL T S Interface

UL guidelines for rack mounting

The following Underwriters Laboratories (UL) guidelines pertain to the installation

of an IPL T S Series unit onto a rack.

1. Elevated operating ambient — If installed in a closed or multi-unit rack

assembly, the operating ambient temperature of the rack environment may be

greater than room ambient. Therefore, consider installing the equipment in an

environment compatible with the maximum ambient temperature speciﬁed

by the manufacturer [Tma =

+32 to +122 °F (0 to +50 °C)].

2. Reduced air ﬂow — Installation of the equipment in a rack should be such

that the amount of air ﬂow required for safe operation of the equipment is not

compromised.

3. Mechanical loading — Mounting of the equipment in the rack should be such

that a hazardous condition is not achieved due to uneven mechanical loading.

4. Circuit overloading — Consideration should be given to the connection of the

equipment to the supply circuit and the effect that overloading of the circuits

might have on overcurrent protection and supply wiring. Appropriate

consideration of equipment nameplate ratings should be used when

addressing this concern.

5. Reliable earthing (grounding) — Reliable earthing of rack-mounted

equipment should be maintained. Particular attention should be given to

supply connections other than direct connections to the branch circuit (such as

the use of power strips).

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 78 79

Pas de commentaire

Extron electronics IPL T S2 Instructions d'exploitation Page 14